Sunday, 7 September 2008

Interior of shower room walls

These pictures show the 3mm plywood internal skin applied in readiness for waterproof covering. The really hard bit was scribing the ply to the curve of the roof and also the ceiling/floor. It turned out really well. Again no straight joins here just curves, the framework at the bottom left as you view from outside the van will hold the thetford toilet waste door, it fits just between the uprights and the horizontal support. I can easily stand outside the sliding door and remove the waste tank without bending down or straining. Again in keeping with the idea there should be nothing on the outside to show it's a motorhome inside, so far i'm doing well.


RonĂ¡n said...

The curves on the walls look really good, trying to do the same myself.
Did you put a framework in behind to curve the ply?

hypnosis121 said...

Excellent job on dealing with the curves... Such a worthwhile project...
Best wishes, Steve