Thursday, 27 November 2008

Kitchen Units








These pictures show the gloss white units and black gloss top. The units are 15mm MDF and custom painted in my own choice of colour with a gloss finish. The unit on the left at the top will house the combination microwave. The units below the sink will be a mixture of drawers and cupboards finished in the same white. The bathroom wall has now got the two wiring conduits in and the fridge has been fixed in place. The hob and sink unit is a SMEV unit with black glass lids, this will match the black glass splashback when it is fitted.

Generator update - the remote panel was attached and the generator started. It didn't output 240V but just went to full throttle before switching it's self off, more investigation needed here.

Saturday, 15 November 2008

Kitchen unit creation




These two pictures show the kitchen unit construction, the material is MDF 15mm for the carcasses, the doors will be 18mm. The units have been dissasembled and sent for sprayfinishing for a gloss Ivory finish. You may be able to see that the holes for the pipes and aircon ducting have been cut.

Sunday, 9 November 2008

Generator nearly there........



Ok I have replaced the malfunctioning component. I have also got the remote control panel so I am almost ready to go, just one thing I need to build a cable to link the generator and the panel, which means buying a plug to fit this socket. More research needed..........

Tuesday, 28 October 2008

Generator



I have purchased a TEC29 Dometic generator from a salvage dealer, it appears to be working except for the component that has blown up in the picture. I intend to replace that and see what happens. The generator is a remote start unit to be located under the van, allowing the usage of high power appliances in the van

Sunday, 7 September 2008

Interior of shower room walls



These pictures show the 3mm plywood internal skin applied in readiness for waterproof covering. The really hard bit was scribing the ply to the curve of the roof and also the ceiling/floor. It turned out really well. Again no straight joins here just curves, the framework at the bottom left as you view from outside the van will hold the thetford toilet waste door, it fits just between the uprights and the horizontal support. I can easily stand outside the sliding door and remove the waste tank without bending down or straining. Again in keeping with the idea there should be nothing on the outside to show it's a motorhome inside, so far i'm doing well.

Friday, 5 September 2008

Shower room frame



This week I have been working on the shower room, this is constructed from 2" x 2" planed timber fixed to the floor walls and ceiling by various methods, the frame is amazingly strong. It will be cladded on the inside and outside with 3mm ply, using curves no straight lines, looks good but very very hard to fit. The area inside the shower room is 1200mm x 1200mm or 4ft x 4ft. This gives loads of room for showering etc. Next post will be the ply cladding inside the shower room.

Monday, 25 August 2008

Rear bed frame


This shows the framework my brother built for me round the air-con unit and also shows the Calorifier I mounted on the wall, the floor under the calorifier will house the water pump, valves for the heating and other water related items. This area is surrounded by a tray like feature that means if there is a leak it drains through the floor and not into the living area, as the hot water will be about 80deg it is probably a good idea. It also shows the two main supports for the rear bed, this again will be slatted and ventilated so we don't need to prop the matress up to breathe. The size of this frame fits a standard 3/4 double mattress. This will probably be more comfy than my bed at home :)